devil emoji cam cover

pinshape

Emoji Cam Cover This isn't a simple print, it's designed to be printed in parts and then assembled as an inlay print. Printed on a Creality with a .35 nozzle and layer height 0.2 using PLA filament from Ctrl Design. Nozzle temperature is set at 210 and bed temperature at 62. Ensure all prints are perfectly centered in your clipper. Step 1: Print the parts of the emoji, excluding the red sections. Step 2: Print the devil's red part 1. Stay with the printer to turn on the heated bed when the print is done. Don't remove the print from the bed; instead, place the other emoji parts into it. Step 3: This is the tricky part. Position the file (devil part 2) 1mm above Z 0 and run it through the clipper to check if it's 1 mm higher than the bed level 0. If not done correctly, the nozzle will destroy the print. If done right, you can start printing now, and it'll go over the existing print on your bed with all inlay parts. Step 4: Measure the device thickness and then print the correct comb clip file. Good luck with this print! This design is printable but not for resale; copyright remains with Ctrl Design.