Desktop Case for 800x480 5" Touchscreen

thingiverse

I got a 800x480 5" Touchscreen as additional interface for my octoprint raspberry. Also I wanted the option to use it as a always on monitor for a CCTV. This is a simple stand, printable without supports. I used M3 nut inserts by ruthex to screw the parts together. There are two throughholes for a cable tie and an indent for a magnet, to secure cables and make it stick to a metallic surface. The Display is mounted upside down, so the output of the raspberry has to be turned by 180°. Parts needed: - 6 M3 nut inserts (or make the holes a bit smaller so that you can screw directly into the plastic) - 90° HDMI plug male/female - 2x 90° MicroUSB for power and touch interface The stand angle and almost all sizes are easy changeable. I'm just a beginner, but I think I created all measurements in dependence of the dummy-PCB-body inside fusion, so changing the PCB sketch should change all other measurements.