Desk Organizer [Side mount]

prusaprinters

<p>[Desk Side Mount Organizer V1.1]</p> <p>Designed to secure onto the side of table/desk/tabletop with 2 tightening bolts, offering extra real estate for organizing your working place.</p> <p>[V1.1] It has 4 storing compartments: phone dock, 2 HDXC/HDSC card slots, general holder (print separately) and a tray section.</p> <p>It is designed to fit onto table/desks that are at max 2.3cm or 0.9 inch thick (see attached picture) - so<strong>measure before you print</strong>.</p> <p>There are 4 parts: main body, a holder and 2 tightening bolts.</p> <p><strong>Important</strong></p> <p>Slowly adjust the bolts until they just grab onto the surface, do not overtighten them as it may crack at the joint (another 20 meters of filament down the drain). Better yet, use tougher materials like PETG.</p> <p><strong>Slicing</strong></p> <p>Print the main body with bottom face up, enable support, and add support blockers at the SD card slots (See below).</p> <p>Print the bolts with higher infill rate.</p> <h3>Cura preview</h3> <p><strong>(Note the support blocker in the middle section)</strong></p> <p class="detail-image"><img src="https://cdn.thingiverse.com/assets/d7/4f/00/1b/5a/Screenshot_620.png"/></p> Category: Organization