Desk lamp

thingiverse

Simple bedside lamp uses less material and has a cable maze for better security, with holes on top for heat dissipation. Printing details: Infill is 30% and layer height is 0.2 mm. Print the cover using clear or white filament and generate build-plate support. Print the base with generated support everywhere. Remove all support from the cover at once. Remove main cable hole and inside cable holders from the base. The E14 hole diameter is 2.6 cm. Assemble instructions: Insert cables through holes, insert the E14 into the support hole (glue it if desired), connect the cable to the E14, screw the support and base together with four PC case screws, screw the E14 bulb into its socket, then place the cover on the base. If the top cover's flower-shaped holes are overprinted, use a knife or small screwdriver to clear them out.