Desiccant container 50x50mm - fast print - vase mode

prusaprinters

<p>A fast printing vase mode desiccant container 50x50mm to fit inside of the spool center during storage.</p><p>Less than 10 grams filament is needed and prints fast.</p><p>Recommended to be printed with PETG (without partcooling) for strength and flexibility.</p><p>On my Ender 3 v2, using a 0.6mm nozzle &amp; PETG, container and lid were printed in less than 40 minutes total.</p><p>Slicer recommendations:</p><p>The holes in the bottom/lid are 1mm deep, adjust the bottom thickness in the slicer accordingly and check the gcode preview.</p><p>Use spiral/vase mode to print.</p><p>A wall thickness of at least 0.6mm is advised for strength (can also be printed with 0.4mm nozzle).</p><h3>How I Designed This</h3><p>It is remixed from a nice redesign from brettvitaz.</p><p>The model is enlarged to 50x50mm and the holes in the top and the lid are replaced by a square grid to minimize the amount of retractions needed.</p>