--DEPRECATED-- Tiny Whoopic - Tiny Whoop alike frame for 8.5mm Motors

thingiverse

DEPRECATED => see my v2 instead http://www.thingiverse.com/thing:1715901 This remix of OscarLiang tiny whoop alike frame for 8.5 motors has several objectives. They are easier to print with no support, weigh less than before at 13g for the main frame and 1g for the FC plate, allow use of 58mm ladybird props for more thrust, are stiffer and less brittle, and are compatible with OscarLiang VTX/camera Mount. Print the frame and FCplate as it is. No support or raft is required, a layer thickness of 0.15, and 100% infill will do just fine. You'll also need to print the vtx mount from the original design: http://www.thingiverse.com/download:2645151 http://www.thingiverse.com/download:2654363 -- Required materials -- 1x Whoopic frame 1x FCPlate 1x VTX Mount (for fpv) 1x Micro scisky board 4x 8.5mm motors 7x small zip ties 1x micro Camera/VTX of your choice 4x 58mm ladybird props (or shorter) -- Build instruction -- Attach the FC to the FCPlate with double sided tape. Then, attach the FCPlate to the main frame using four zip ties. Pass them through the bottom hole, then the side hole. Next, attach the motor inside the motor mount. They should fit tightly. Secure them with a little spot of hot glue. Finally, attach the VTX mount to the frame using three zip ties. Print Settings Rafts: No Supports: No Resolution: 0.15 Infill: 100%