Deltaprintr Extruder Upper Block

thingiverse

This block replaces the original wooden upper part of the Extruder on Deltaprintr. You may need to drill holes with a 3mm Drill bit so the Filament and Screws fit perfectly. However, do not drill the lower hole where the Pulley fits into. If you don't drill all the way down, the Screw will hold in place much better. Print Settings: Printer Brand: Deltaprintr Printer Model: Deltaprintr Kit Raft Thickness: Any Value Support Material: Not Needed Resolution: 0.25 mm Infill Density: 15% Printing Tips: The print must be oriented "Upside Down" to get the best results. If you're printing it "Laying on its Side", you may need to clean it up a bit more. To print successfully, slow down your speed and provide good Cooling. Post-Print Assembly: Drill holes with a 3mm Drill bit so the Filament and Screws fit correctly. Leave the lower hole un-drilled as this is where the Pulley fits in. Test the assembly and let me know if I can improve the design further.