Delta Rostock Kossel Effector e3d V6 with 8mm probe

cults3d

A single 40mm fan is required to cool the heat sink, which is screwed into four located holes on the rear. The cooling nozzles use a self-tapping screw or another method that passes through them down into the effector. The nozzles utilize 5015 blowers that will sit over the top without needing any hardware. A clamp ensures the hotend stays in the effector, using two M3 bolts that thread into holes that are 2.5mm in diameter, allowing you to tap them or use self-tapping screws if desired. Within the bottom of the effector is a relief for cables to transit out from the heater block. The arm distances for delta settings are 42mm. The offset from the center of the effector to the rods is 37mm. Probe offset is 25mm. This product is an alpha prototype, and as such, it may not work entirely until all issues have been found and resolved. Please alert me to any potential problems or modifications you might want.