Delta Rod Jig

prusaprinters

<p>Another Delta Rod Jig. This one is for use with Traxxas 5347 with the hollow ball installed in the rod end. Use a M3 x 15 screw in the jig. Depending on your printer you might need to run a 3mm drill through the center hole. Don't ream the hole out too much as you want the bolt to stay tight in the hole.</p> <p>Measurement from the c/l of the screw to the edge of the jig is 7mm</p> <p>Measurement from the c/l of the screw to the c/l of the mounting hole is 11mm</p> <p>Measurement from the c/l of the screw to the front edge of the block is 15mm.</p> <p>So if you want 280mm on center rods, space the blocks 250mm apart. (280 -15 -15 = 250)</p> <p>Added rod cutting jig to the collection</p> <h3>Print Settings</h3> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div> <p><strong>Resolution:</strong></p> <p>0.2</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>15%</p></div> </p></p> Category: 3D Printer Accessories