Delta printer effector for NF-TC01 dual extruder Ver3

thingiverse

I was not satisfied with the designs found here, so I designed my own to maximize available print height. This supports a dual extruder named "NF TC-01", which can be purchased on aliexpress/ebay. To install it, the extruder cables must be bent at a sharp angle; do this at your own risk (it has worked for more than half a year now). It also requires a few M3 screws. I recommend adding a silicone sleeve to the hotend, as otherwise it may melt nearby PLA; printing with something more heat-resistant is also recommended. The underside provides space for captive nuts to mount push rods using M3 screws. It supports two 40*10mm turbo fans with built-in fan shroud. A BLTouch is located on the back side, featuring self-tapping holes for M3 screws. Another version features a different type of leveling sensor: a simple toggleable switch probe that lies on a lever printed separately. Some 2-sided tape is required. Link: https://tinyurl.com/y4s6v4xo This proved to be significantly more accurate than the BLTouch I had.