Delta Corners for Inline Belt Placement (V-Slot)

thingiverse

***This setup hasn't been fully tested yet. Use at your own risk.*** This Thing is an experimental delta design intended to accomplish a few things: - Provide a workable delta parts with robust source files. - Decrease the difficulty inherent in most delta builds. - Decrease the difficulty of maintenance without compromising the quality of prints. At the moment, this is carried out via three major components: - The corners, which are designed to allow for GT2 belt to run vertically and within the groove of the rail - Mini V-Plate covers which hold magballs 55mm apart and provide easy belt mounting. - Idlers, which rest at the top of the rails at each corner. A ***non-exhaustive*** BOM has been provided. As this thing is still in progress, you may want to hold off on making any purchases until I do a tear down to capture all the hardware, or you want to use the source files to figure it out for yourself. At this precise moment, tolerances are a bit unforgiving; I find that just a bit of the material gets shaved off by the rail. I will address this at some point, but just know you may need to do some work to get the parts in place the first time.