Dell USB-C Dock Port Saver (WD15 + Latitude 7390/7490)
prusaprinters
At first I just wanted to change the height of the original model to fit my Latitude 7490.After printing small slice of model to test fit, I realized that's all you need. It prints below 10min and uses ~30cm of filament. Tested with Latitude 7390/7490 and Vostro 5471. Since it slides deeper on the connector, it should also be compatible with computers that have a usb port located a little higher or lower.Print instructionsI recommend at at least 3 perimeters, infill shouldn't matter then. You can go all the way up to 100% - filament usage stays almost the same. Fit instructionsYou should slide it so that the top side of the printout is looking towards computer. If you're not sure, try both ways - correct is when it slides deeper onto connector.
With this file you will be able to print Dell USB-C Dock Port Saver (WD15 + Latitude 7390/7490) with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Dell USB-C Dock Port Saver (WD15 + Latitude 7390/7490).