Deflector StadlerForm Eva Little Humidifier

prusaprinters

<p>New <strong>Version 1-1</strong> has a much better fit. The Version 1-0 hat some issues, that the mist came out from the side and it was very wet on top of the humidifier after a few minutes.</p><p>&nbsp;</p><p>We have the “Eva little” humidifier at home. It's a great humidifier with integrated hydrostat. And there's the problem. It's integrated and the mist always falls down and the humidity rises so the device stops until the humidity is down again. Also it's not really ideal, that the mist only goes straight up, because it would be better it goes a bit away in front of the device. That, because we have some other things around and I don't want the mist on them.</p><p>I don't know if it's also compatible with the normal “Eva” humidifier. On the pictures, it does look like it could also fit.</p><p>&nbsp;</p><p>&nbsp;</p><p><strong>IMPORTANT!!</strong></p><p><strong>There is one end, that is about 10mm straight and not bend, this is the lower side.</strong></p><p>&nbsp;</p><p><strong>Print Settings</strong></p><p>0.20mm Quality Setting for PrusaMINI in PrusaSlicer</p><p>Print with brim. Otherwise I don't think it would stick to the printbed.</p><p>Infill: Standard, doesn't really matter</p>