Deep Six Diver for fishing

thingiverse

This is a replacement for a size 2 deep six diver. My last one broke and they are very hard to find in local stores so I reverse engineered it and put the printed one together with all the hardware from the broken one, except the rear swivel where I used a split ring instead of the soldered ring. Print flat side down with 100% infill. The bottom fin could use some support but I printed without and it came out just fine. 4 walls to make sure there is enough strength around the holes. The hole for the top locking bracket and the hole for the weights are slightly undersize so you can drill them to fit the fastener of your choice. I used a 3/16 pop rivet for the locking bracket and a M5 bolt/nut for the weights.