Deep Crimper Pegboard Holder - 25mm Deep 50mm Wide

prusaprinters

This pegboard crimper holder is deep enough for the thicker crimpers used on Dupont connectors and some models with interchangeable crimping bits. In addition to those types of crimp tools it's useful for attaching a variety of RJ45 Cat5 ethernet network wire crimp tools to peg boards. Print instructionsCategory: Tool Holders & Boxes Print Settings Printer Brand: SeeMeCNC Printer: Rostock MAX Rafts: Doesn't Matter Supports: Doesn't Matter Resolution: .2mm Infill: 30% Notes: This printed well with PETG, ABS, and PLA on the Rostock max. Some of the PLA parts were a bit too brittle although that might be a factor of the heat setting being too low and not enough infill. PETG and ABS seemed to be reliably sturdy. Instructions Using the following options: holder_y_size = 25 holder_height = 15 strength_factor = 0.66 holder_offset = 0.0 taper_ratio = 1.0 holder_angle = 0.0 corner_radius = 10 holder_cutout_side = 0.0 holder_x_count = 1 holder_x_size = 50 closed_bottom = 0.0 holder_y_count = 1 wall_thickness = 1.85