Deep Crimper Pegboard Holder - 25mm Deep 50mm Wide

prusaprinters

<p>This pegboard crimper holder is deep enough for the thicker crimpers used on Dupont connectors and some models with interchangeable crimping bits.</p> <p>In addition to those types of crimp tools it's useful for attaching a variety of RJ45 Cat5 ethernet network wire crimp tools to peg boards.</p> <h3>Print instructions</h3><h3>Category: Tool Holders &amp; Boxes Print Settings</h3> <p><strong>Printer Brand:</strong> SeeMeCNC</p> <p><strong>Printer:</strong> <a href="http://amzn.to/2GEXcmB">Rostock MAX</a></p> <p><strong>Rafts:</strong> Doesn't Matter</p> <p><strong>Supports:</strong> Doesn't Matter</p> <p><strong>Resolution:</strong> .2mm</p> <p><strong>Infill:</strong> 30%</p> <p><strong>Notes:</strong></p> <p>This printed well with PETG, ABS, and PLA on the Rostock max. Some of the PLA parts were a bit too brittle although that might be a factor of the heat setting being too low and not enough infill. PETG and ABS seemed to be reliably sturdy.</p> <h3> Instructions</h3> <p>Using the following options:</p> <p>holder_y_size = 25<br/> holder_height = 15<br/> strength_factor = 0.66<br/> holder_offset = 0.0<br/> taper_ratio = 1.0<br/> holder_angle = 0.0<br/> corner_radius = 10<br/> holder_cutout_side = 0.0<br/> holder_x_count = 1<br/> holder_x_size = 50<br/> closed_bottom = 0.0<br/> holder_y_count = 1<br/> wall_thickness = 1.85</p>