Decorative litte vase

thingiverse

I truly appreciate it if you click the Like-button when downloading this model. I designed this small vase using shapeshifter.io and printed it with my Felix 3.0 printer. Note: This vase is not water-tight, so do not fill it up; instead use it purely for decorative purposes. Check out a quick video of how fast this piece prints in just a short time-lapse movie on https://www.youtube.com/watch?v=A1hZuxFdbi8. The settings used are shown below: Instructions Slic3r 1.1.7 Layer height: 0.2 mm First layer height: 0.5 mm Perimeters speed: 30 mm/s Perimeters extrusion width = 0.50 mm Infill extrusion width = 1.00 mm Solid infill extrusion width = 0.85 mm Printed with PLA at an extruder temperature of 195°C (first layer at 200°C). Printer bed set to a comfortable 55°C, raising to 60°C for the first layer.