DeBowler

thingiverse

I've always been fascinated by the de-bowler, and after finally getting my printer set up, I was eager to give it a try - it was one of the first long prints I attempted. However, the initial design that pushed me to my limits didn't quite turn out as planned - the ears and the debowl prong came out too thin. This setback only fueled my determination to create one of my own. The base features six sides, while the internal components have a similar design but rotated at each midpoint. The top is a 36-sided circle, carefully crafted for maximum symmetry. With a width of just 0.7mm, the top of the de-bowler tool should be both sturdy and thin enough to deliver exceptional results. If you do decide to print one, please share a picture - it would be fantastic to see this project spread its wings and help those in need of a reliable de-bowler.