
Death Archon Proxy
thingiverse
After seeing the new model for the Death Archon in Warmachine/Hordes, I thought it looked familiar. I looked up the Reaper Form of Death from Darksiders 2, and decided it was close enough. It took me hours of searching, but I finally found a 3D model of it here: https://assetsdownload.com/free-skeleton-death-with-scythe-3d-model/ Anyway, the model is so close that I barely had to change it. I did add some stuff though. I used this skull for the belt: https://www.thingiverse.com/thing:1040192, these ribs for the ribs: https://www.thingiverse.com/thing:4331732, and the wing bits from this model cause I couldn't figure out a good way to do it: https://www.thingiverse.com/thing:1592690. I would add these to the remix section, but that doesn't seem to work anymore. Unfortunately, every time I tried to run it through Netfabb, it would fail to load the mesh, and running it through other fixing programs failed to rectify it, so I'm just uploading it as is, but that means somethings wrong with it somewhere. When I print it, I'll update this description with how it went. I put it on a 50mm base that I made a while ago in Inventor, and added a hole for a magnet. I'll be printing this on an Elegoo Mars. Edit 11/24/2020: I tried printing this and the wings did not work. I replaced the wing material with the wings from this model: https://www.thingiverse.com/thing:4391098 Still doesn't work in NetFabb though. Edit 11/25/2020: I tried printing again. This time the wings did work, but the claw tips on the wings are too pointy to connect to supports, so I thickened the tips.
With this file you will be able to print Death Archon Proxy with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Death Archon Proxy.