DDW 1/10 RC M-Drift 2 RWD Chassis

thingiverse

***5/28/21 Update: Video of a prototype running - https://www.facebook.com/DarkDragonWing/videos/837994550428013*** ***12/28/21 Update: The assembling video should be out in early 2022.*** ***DDW_M-D2R09_Diff_Cover_F_B.stl has been updated to have thicker walls.*** ___ **Website** http://www.DarkDragonWing.com **YouTube** https://bit.ly/YouTubeDDW **Facebook** http://bit.ly/FacebookDDW **Online Store** https://bit.ly/ebayDDW **Product Recommendations** http://bit.ly/amznDDW ___ **Software:** Cura **Layer Height:** 0.2mm **Infill Density:** 75% **Materials:** PLA, ABS **Wall Thickness:** 4mm **Top/Bottom Thickness:** Same as Wall Thickness **Filter Out Tiny Gaps:** ☑ or ☐ as you see fit ___ **Videos:** Coming soon! **Required Items:** https://bit.ly/3yqsgR8 **Recommended Actions:** 1.Print "DDW M-D2R07 Motor Mount.stl" with ABS. 2.Use a cordless drill to hold the ball stud by the thread side and then push and drill the ball side into its place in the control arms or the links. Continue to spin the ball until it's moving freely inside its place. Apply a tiny bit of grease to the ball at the end will also help. 3.Use a soldering iron to heat up the brass nut and then pull it into its place using an M2x20 screw. 4.Replace the soft shock springs with the new strong ones. **DDW 1/10 M-Drift 2 RWD Chassis Specs:** Ride Height: 3-12mm Servo Suspension (Adjustable) Turning Angle: ~50° Front Kingpin Angle: 9° Front Caster Angle: 9° Width: 195mm on 3mm, 205 on 6mm, 210 on 9mm Wheelbase: 257-263mm (Adjustable) Front Shock: Leaned In 0°, Leaned Back 5° Rear Shock: Leaned In 0°, Leaned Back 0° ___ ⚠️ Disclaimer: This section contains affiliate links to products. We may receive a commission for purchases made through these links.