DDR4 Freezer

thingiverse

Before installation, it is advisable to measure the slot width, on this mount it is 32.5 mm. The mount may overlap the vent holes of some video cards, keep this in mind, in my case, the overlap is slightly better to print ABS, because the air flow from some video cards can simply float the PETG. After printing, carefully remove the supports, the peel may remain and the mount will not fall into place. It can be installed without a rubber heel on the stop, but in this case, unnecessary vibrations are possible. It is better to use a fan with the highest airflow. The PC case should be as purged as possible, if you have a temperature of more than 50 degrees in the case, no blowing will help you. It is not advisable to place the mount on the components of the motherboard (PWM controllers, capacitors), the mount may melt or damage the components, use a support to lift the mount above the motherboard, prop it up without much effort, otherwise the slot may be damaged. The author is not responsible for damage to the components, the model is experimental, use at your own risk.