ddr gen1 stage corner bracket filler/spacer - panel wiggle reducer

thingiverse

this remix made the filler fit better in gen1 ddr arcade stages biggest change was making it extend out a little to almost completely eliminate panel wiggle I made this for my routed panels but it should be fine either way your results may vary as there will be small inconsistencies with the metal switch frames 1. install top piece, use a screwdriver to help press it in 2. slide bottom piece in all the way to keep panel from hitting it no special instructions, pla is fine, .2mm or thicker layer height is good, low infill % side note for anyone routing panels, a small metal file can be helpful for quickly making fine adjustments to areas you cut as well as smoothing them out one issue I had was the cut not being deep (as in panel thickness) enough, and the table mounted dremel with router attachment I was using somehow didn't make it easy to level out, so filing down the ends of the cut was an easy solution to that