Davinci Internal Spool Holder

thingiverse

A basic clamp-together system holds a standard filament reel on some bearings. Designed for my Davinci 1.0A printer, the rack attaches on the right-hand side and features two clips which secure it into position by matching with notches on the base of the printer. Bearings are 8mm OD by 3mm ID in diameter, and there are two on each axle making a flanged roller bearing design. Mounts should be M3 screws measuring 10mm in length, preferably countersunk on the tabbed side as it is a tight squeeze. Instructions: Print all the pieces at once, which took about 4 hours with my Davinci 1.0A using standard settings and 15% infill. It may come out a little flimsy, so increasing the infill if making another could improve the design.