Dash mount phone (Samsung A32)

thingiverse

I decided to upload this in case any of the other two or three people who have the same phone configuration as I do might be able to use it. This was made in tinkercad so I'm including the obj file in case you can edit it for your own purposes. I made this specifically for my A32 which is a heavy phone with a thick (16-18mm) soft case. This configuration is held onto the dash by sliding the two spatulas into a crease in the dash. Two screws and nuts attach the spatulas to the back. Both are necessary to be strong enough to hold the phone in place without it twisting and bouncing. In this case I left the top and bottom support pieces in because it looks cool. You'll want to print two each of the slide-in (spatula) part and two of each nut and bolt. The phone slides tightly into place and the side pinchers are slightly thinner than the phone to create some tension there. It can even hold the phone by the bottom with just the two side pinchers. If you put it with the power button down, the up volume button will be inaccessible. The other way and your built-in speaker is pointing away from you and might be blocked by the side pincher. But if you're using bluetooth audio from the phone then the speaker doesn't matter anyway.