Dasaki RAMPS32 for Mega, DUE, Re-ARM, GrandCentralM4

prusaprinters

<p>This Dasaki case will fit the following MCU's:</p> <p>Arduino Mega 2560</p> <p>Arduino DUE (not physically tested yet)</p> <p>Adafruit Grand Central M4</p> <p>Panucatt Re-ARM</p> <p>It has plenty of height room for the MCU, RAMPS board, Step Stick Protectors, Step Sticks, and heat sink's</p> <p>There is enough horizontal and vertical space to fit a new RAMPS 2.x 32bit board design and LCD adapters for Mega/Grand Central M4 and an extended Re-ARM LCD adapter.</p> <h3>Print Settings</h3> <p><strong>Printer:</strong></p> <p>Piper2 CoreXY</p> <p class="detail-setting rafts"><strong>Rafts: </strong> <div><p>No</p></div> <p><strong>Supports:</strong></p> <p>No</p> <p class="detail-setting resolution"><strong>Resolution: </strong> <div><p>0.2mm</p></div> <p><strong>Infill:</strong></p> <p>15% to 30%</p> <p><strong>Filament:</strong></p> SUNLU PLA <p><br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>4 top and bottom layers and 4 walls.</p> 30% infill is good for the case and cover unless you want to use clear filament for the lid, then decrease to 15% infill. Case should remain at 30%. <p>No supports are needed.</p> <p>Both the case and cover is designed for a 60mm fan. Openings are walled off but cut out very easily.</p> </div></p></p> Category: 3D Printing