Darts Case for Tungsten-Softdarts

thingiverse

As I don't want to carry a complete toolbox to the pub every time, I designed this case. It fits three darts as well as about 50 points and several stems, and easily fits in a jacket pocket. Tested with Evo-Points, Tuflex-Points, and some no-name-points as well as standard-flights and quite the whole unicorn-range including 150 micron flights. This case is still a work-in-progress, at the moment there is only one version for darts with a length of approximately 134 mm. They may be three millimeters longer if you use Slik-Sticks or flight protectors that fit into the holes in the cover. There will be more files for different lengths available in the near future. The diameter of the dart barrel should not be bigger than approximately seven millimeters. As a change in diameter would cause a complete new design process, I do not plan to increase the possible dart diameter at this time. Depending on your printer's accuracy, print with outer walls first and set the width of the first layer to 100%. To get the darts out, remove the cover, cover the two compartments with two fingers, and gently shake out the darts.