
Darth Vader Lamp
myminifactory
Hi there! Check out my Darth Vader-inspired lamp! This project started with a $19 Australian bundle of two typo LED lights, which I grabbed because they came in pairs. Next, I used some Darth Vader black filament to give the light its ominous tone. After about three hours, I swapped the roll for a bit of red to add some flair. You can do this too, but I think it really brings out the "devil" in the lamp with that bold color. I also added a little cylinder to the end of the typo light. This tiny piece has a battery compartment near the bulb, and when you pull the cord, the light turns on. To make it more interesting, I fed the light from underneath and used the cylinder as a stopper if needed. If you decide to make this lamp, be sure to add some photos to show off your handiwork! And don't worry if the hole is tight – just warm it up with boiling water and fit in the typo light. It'll stay put once it's cooled down. I hope you enjoy making this Darth Vader-inspired lamp as much as I did! Thanks again for checking out my project!
With this file you will be able to print Darth Vader Lamp with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Darth Vader Lamp.