Dartboard LED Ring

thingiverse

Update 05.04.2020: Upload holders 40mm closer to the board for testing purposes. These parts are not for testing, but if you do test them, please comment on your results. Update 04.04.2020 New Description: I reconstructed this design in Fusion 360 for easier editing. I edited the connection between the ring parts to enable printing in two separate parts, eliminating the need for supports. I used 10mm LED strips but found that 8mm worked better (version 1 only). I modified the bracket and used three 6mm x 3mm magnets to attach it to the dartboard, creating a cable duct as well. I purchased these magnets from Amazon. There are two distinct versions of this design: V1: The LED strip is perpendicular to the board. Main dimensions are 15x15. - 8x Achtel_without_connector.stl (10x 10tel_without_connector.stl for smaller print bed size) - 8x Achtel_connector.stl (10x for smaller print bed size) - 3x Bracket_standard_V1_1.stl - 1x Bracket_for_bottom_Cable_V1_1.stl - 1x Cablecover_for_bracket.stl V2: The LED strip is at an angle of 25° from V1. Main dimensions are 18x18. - 8x V2_25_Achtel_without_connector.stl (10x V2_25_10tel_without_connector.stl for smaller print bed size) - 8x V2_25_Achtel_connector.stl (10x for smaller print bed size) - 3x V2_1_25_Bracket_standard.stl - 1x V2_1_25_Bracket_for_bottom_Cable - 1x Cablecover_for_bracket.stl I recommend gluing the magnets to prevent them from coming loose. I used gaffa tape on the holder side of the dartboard, which worked perfectly. The outer diameter of the ring is 660mm, and the height is 125mm. The space for the LED strip is 10mm. It's crucial to print the bracket with a cable duct in the correct direction to avoid supports. Great work by Klammerson - thanks!