Dart Zone/Adventure force Matrixfire Stock Adapters (N-Strike and Buffer Tube)

prusaprinters

<p>Add a stock to your MatrixFire by removing the orange sling point.</p><p>&nbsp;</p><p>Printing</p><p>-Orientation: as it is in the file</p><p>-Walls: N Strike: at least 3</p><p>Buffer Tube: 5 (The length and rigidity of a buffer tube stock makes it more likely to experience shear forces across layer lines)&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;</p><p>-Infill: 20 was enough on test prints</p><p>-Supports: No, Stock Ender 3 could handle these prints.</p><p>-Post processing: This print is intentionally tight so that it is stable.&nbsp;If it isn’t fitting in your blaster well, cut away or drill out some of the “circles” at the top of the print</p><p>&nbsp;</p><p>Installation</p><p>-Open the blaster</p><p>-Remove the orange sling point</p><p>-Drop the stock attachment point in where the ling point was in the same orientation (Broken circle “up”)</p><p>-Ensure the print is seated correctly and snugly</p><p>-Close the blaster</p><p>Note that the one long screw on the blaster goes in the screw post which goes through the stock attachment point’s open circle.</p><p>&nbsp;</p>