Dart Launcher

cults3d

This is a dart launcher that I designed that will fit onto your arm/wrist. There are two types you can print. This first one is "launcher main" which comes with a cover for your fingers so that it is more like a gauntlet. If you do this one, you need to use supports and to print the normal launcher grip. If you do the "launcher main no shield", you can either do the normal grip or the extended one (as shown in the pictures). You do not need supports for this one! For ammo, the normal one most likely will require some sanding but it is a bigger round. The smaller one should not require sanding but it is about half the width. The launcher stopper/activation part is used to put tension onto the back of the dart to launch it (put it in the lowest triangle and push it like a button). You will need an elastic of some type. You can either use the guide holes on the launching mechanism or you can just wrap it around and hook it onto the posts in the back of the mechanism like I did in the picture (wanted multiple different ways since not all elastic bands are the same) Hope you enjoy it!