Dark Phantom aka DP-1x by Yamie

thingiverse

Started with the idea of printing a miniKwad and i've found the DP-1x made by Eill. As he doesn't provide any frame files, i've asked in our fpv-community forum to re-create this frame and someone (Yamie) just did it. I had to modify the bottom part a bit, because the DarwinFPV AIO Board didn't fit (the USB port is a bit more to the back), and to maintain more space for the USB port from the ground, i had to add some raisers for the board. The Insta360 go mount is another remix. I cut off the bottom part of the mount, and added a fitting part for the DP-1x (20x20). Building: 1a) If you're using the Insta360 go mount, you definitely should mount the side panels first to the go mount! 1b) Then you should place your camera 2) The middle part needs to be prepared with the two little standoffs and placed between the two panels and be screwed tightly with M2x3 (maybe M2x4, not longer!) 3) Now screw the front swinging part with two M2x6 onto the bottom 4) Time for the whoop board: i used two M2x20 for the right/left of the board and two M2x25 for front/back (this is where the vtx is mounted) screw from bottom: - 3s battery holder (can hold 2s and 3s gnb) - bottom frame - whoop board with gummis/grommits 5) Place the AIO board as you always do and mount the four motors 6) Wire everything up and do a first test (don't forget the antenna on your VTX!!!), the XT30 fits nicely through the rear middle triangle! 7) Route the wires nicely and fix the with mounting tape and secure the board with nuts and/or some printed TPU. UPDATE I: after remix-creating the insta360 go v1 mount, i know have remix-created the runcam thumb mount. the original part was way too loose, so i removed about 2mm from the middle and now it fits nice and snug. UPDATE II: added updated versions with dual motor mount, for 3 and 4 hole base motors. UPDATE III: added modular version for runcam thumb and insta360 go v1. maybe this will also reduce jello.