Dark Brotherhood Seal

thingiverse

I came across an image of the Dark Brotherhood Logo online and imported it into Tinkercad, where I built upon an external wall and added a handle. The design is intended to mimic a bas relief type seal, with the logo pressed into the wax. I chose this style because the logo always appeared as though someone had slapped a bloody hand onto whatever surface it was on. With this in mind, the finished product will give the impression that the hand is being pressed into the wax. As for suggested usage, after placing the sealing wax, delay impressing the seal by just a few moments longer than normal to allow it to partially set. This will enable it to take a good impression from the seal, as this design was optimized for use with a filament printer, rather than a metal or carbon fiber one.