Danby Simplicity Oven Knob

thingiverse

This is designed to fit a Danby Simplicity Oven. Its got a hole with 2 half moons and then inside has some micro half moon and micro square. Take a look at the picture of the original vs the model. You'll notice I didn't include the micro square inside because its not really needed. This will fit on snuggly and works just fine. It looks similar to the original knob but is just a couple mm smaller but once on the over I am hard pressed to notice. Picture note: I printed this on a Ender 3 S1 with supports. This was probably not a great Idea because I had trouble getting the support material out of the holes. Its probably better to print without supports, or rotate 180 degrees and do supports. I damaged it a bit pulling out the supports and also had some layer shifting during print due to recently moving my printer to an unstable base. Either way it came out alright and functional so I did not reprint