Dan's E3DV6 Triple 40mm Fan Shroud

thingiverse

I'd love to see your prints! Here's my print settings: Printer Brand: RepRap Printer: P3Steel Rafts: Doesn't Matter Supports: No Resolution: 0.1 - 0.3 Infill: 10% Notes: I had to tone down the solid infill in slic3r for the first few layers, as 70mm² was too much and would cause the print head to dig into the layers. Cura sliced them up perfectly, though! A large brim was needed to keep it from lifting. Post-Printing: 1. Use super glue to bond the three parts together. 2. You can adjust the distance between the bed and print head while assembling. 3. I used hot glue to secure the fans in place, but you can also drill M3-sized holes and use M3 12mm hex nuts for a more permanent solution. Assembling this setup was a breeze using Blender and DWONH's design.