DAM P1 210

thingiverse

DAM P1 210 is a speedy design I conceived to print and fly at lightning speed without breaking the bank on frames that didn't meet my aesthetic standards. It's perfectly balanced and spot on, flying smoothly every time. I've been relying on the DAM P1 210 as my primary quad for about three weeks now. Quadcopter Print Settings Printer Brand: Robo 3D Printer: R1 ABS + PLA Model Rafts: Doesn't Matter Supports: No Resolution: 0.2 Infill: Varying between 60 to 100 percent, depending on the desired level of lightness. Notes: Printed using high-quality Carbon fiber PLA and slicing software Simplify3D. 6 - Top Solid Layer 6 - Bottom Solid Layer 6 - Outline Perimeter Shell This is a 210 frame setup. I utilized 30mm standoffs from an old ZMR 210 kit. I'll need to update the instructions with the screw information later on. The camera mount is specifically designed for the RunCam Swift. I'm using Kensum 2204 motors with a 2300kv rating, paired with Little Bee 20amp ESCs and CPPM D4R. Both dual and tri-prop configurations work seamlessly. The motor holes only accommodate a 16-19mm spacing, so I use two holes for structural reasons.