Daisy 880 Pellet Loader

thingiverse

This is a single pellet loader for Daisy 880s and Winchester 1977s (177 cal). This loader attaches to the dovetail rail with M3 x 25mm screws and nuts. To use, slide a pellet in the ramp with the gun tilted slightly muzzle down and bolt up. Work the bolt and the pellet will load. If a jam were to occur the mag/ramp can be slide away from the bolt in the loader body to expose the bolt and chamber. The mag/ramp has been tested with H&N barracuda and JSB Exact pellets. Some pellets may not work with the current mag/ramp. I will be adding additional mag/ramps in the future for other pellets such as the JSB Beast. I printed this in ASA for UV stability and flexibility. I cannot speak to the functionality of other materials for this model. While multiple pellets can be loaded in the MAG/ramp there have been mixed results when loading multiple pellets in the mag/ramp. Jams may occur if multiple pellets are loaded at once. I will continue to work on a multi mag capability and will update in the future. To assemble slide the mag/ramp into the body. This can be done before assembly by sliding the load end of the mag/ramp into the bottom of the body in the cutout for the mag/ramp. Alternatively the mag/ramp can be installed or removed with the body mounted on the gun by tilting the mag/ramp to insert the tab on the top and feed end of the mag/ramp into the slot for it in the body of the loader then slide the mag/ramp down to the bolt. Press the mag/ramp into the body until it bottoms out on the bolt with the bolt closed. Cycle the bolt to set the mag/ramp position. Friction will keep it in place or the pellet door can be inserted using the tab on the bottom of the pellet door and the slot in the bottom of the body below the mag ramp. See for more info: https://thedaisybase.com