Dagoma Discovery 200 handle/poignée

thingiverse

These handles fit perfectly on the original parts of the Discovery 200 and provide a better grip when moving the printer. They are attached from underneath using the Z rod screws (which will need to be replaced with longer ones). Two internal screw holes were added at the bottom for future modifications, such as adding a machine base. A STL version without these extra screw holes is also available. Print Settings Printer Brand: RepRap Printer: Dagoma Discovery 200 Rafts: No Supports: Yes Resolution: 0.2 Infill: 40% Notes: Printed in PLA and it's strong enough. The supports are absolutely necessary. A minimum of 40% infill is recommended, as the handles will be holding the weight of the printer. Post-Printing BOM You'll need: x4 M3x20mm screws to replace the original ones (which are a bit too short) x2 printed handles Assembly Remove the two Z rod screws from one side of the printer Carefully lift the side of the printer by 3 or 4 cm Insert the handle from underneath Align the screw holes Secure it with x2 M3x20 screws Repeat for the other side.