Daftpunk Helmet [Thomas Bangalter] _Credit to Pedro Ruiz @adafruit

thingiverse

I separated the print into six distinct sections to accommodate smaller printing surfaces, 200x200x180 in size. I'll add more photos as I obtain them. Enjoy this update. Print Settings: Printer: My go-to device for this project is a Wanhao i3 clone. Rafts: Not required for this specific print job. Supports: Yes, necessary to ensure stable printing. Resolution: The resolution used was .2, delivering crisp details. Infill: I opted for 75% infill, but 20% could also be suitable depending on the desired outcome. Notes: These were long prints requiring careful temperature control. I utilized a heated bed with Hatchbox PLA filament set at 200°C on the hotend and 60°C on the bed.