Dab Pen Holder W/ Weighted Base

prusaprinters

A pretty straightforward print for holding your dab pen straight up and down. My girlfriend and I were constantly knocking over the dab pen upon setting it on the desk so here's my solution to that.I made mine out of PLA so I went with the basics for mine, 215 for my extruder and 75 for my bed. I did print with a brim to prevent any kind of warping.The bottom half can fit about 20 pennies in it, I do recommend filling it to the top for the most weight.Finally, I finished it off with 4 #6 screws, the hole diameter is .16 (in) and I printed mine off before I finished the model. If the #6 doesn't fit, just use a #8 and it should be fine.EDIT:I forgot to mention that the top half of the print works by itself, I just added a little bit of weight to it because I tipped it over a few times after printing it.