Da Vinci Pro 120mm Fan in Handle Mount

thingiverse

I fashioned a 120mm fan mount that fits snugly into the Da Vinci printer's handle, utilizing the only 120mm fans I had available. To accomplish this, I modified LeoDuhVinci's 1.0 Fan Mount to accommodate the 120mm fans. Some airflow is compromised, and I may attempt to improve upon this design in future iterations. Next, I employed ffcp01's vent duct mounts to craft an extractor tube from the printer itself. I positioned one fan at each end of the tube, running them on low-noise adapters, which seems to effectively suppress any ABS odors entering the room. Unfortunately, the mount didn't stay securely in place as it warped during printing (bad heat bed), but the handle's shape remained intact. Electrical tape proved sufficient to hold it in position. The print settings were 0.25mm layer thickness with 10% infill.