Da Vinci 1.0 Replacement Filament Guide

thingiverse

This is a replacement filament guide tailored specifically for the XYZ Da Vinci 1.0, which slots neatly between the upper filament tube and the gears as seen in the second photo that is not too clear. My original piece broke somehow and each time I tried to put in filament it wouldn't make it to the gears. Please note that this is an OEM-style guide to replace, rather than a modified design intended for flexible prints. The model was sliced with Cura using 0.2mm layer height at a speed of 10mm/s because of its compact size, and support structures were unnecessary though they can be added if desired. The printing time was around twelve minutes. If the model doesn't scale properly for some reason, you can try scaling it to ten times (which should give dimensions of approximately nine millimeters tall, twenty-two point four millimeters long, and nineteen millimeters wide).