Da Vinci 1.0 Rearview Mirror Clips

thingiverse

Human: Rearview mirror supports for Da Vinci 1.0, This attaches a piece of 6mm mirror to the back of your machine, allowing you to see what's happening behind your extruder and print carriage while it's in action. It's a really handy accessory. Print one of each left and right. Printer settings are as follows: Print with the Da Vinci 1.0A printer, which has been modified with E3D-v6 hotends and Repetier V92 firmware. Settings: * Rafts: Not necessary * Supports: Not required * Resolution: 0.3mm * Infill: 20% Post-printing Instructions: Cut a piece of scrap mirror that is 6mm thick x 310mm long x 51mm wide from a local glass supplier or home improvement store. A thickness of 6mm is common for bathroom mirrors and can be obtained easily. Use a $6 glass cutting tool to cut the glass, making sure to wear gloves and safety goggles. Place the mirror into the clips and secure it with electrical tape to protect your cable bundle. Make sure to push firmly until the clips snap into place. You may need to remove the leftmost screw for clearance. Note: If you are using Repetier firmware, disable the top lid switch by going to [Config]-[Firmware EEPROM Configuration] and setting "Top Sensor On" to zero. Alternatively, use something to block the sensor on the right side of the machine, such as a small scraper that comes with your printer.