Da Vinci 1.0 Pro E3DV6 front cooling system

thingiverse

This is a front cooling system for Da Vinci 1.0 Pro with E3DV6 cartridge. It's absolutely crucial! If you want to utilize the original PCB board from your cartridge, which I've thoroughly tested, you must use: https://www.thingiverse.com/thing:2448508 If, on the other hand, you prefer to use a PCB board from bdwalker1, you'll need to use his specific design at: https://www.thingiverse.com/thing:1328848 Keep in mind that those two PCB boards are distinctly different and have varying dimensions. When using cartridges of this type, your nozzle will be shifted downward by approximately 9mm. This is why it's essential to incorporate my cooling system project into the design. To achieve optimal results, you'll need to utilize two fans, each running at 12V, as specified in the following link: https://www.ebay.com/itm/252029796284 For maximum performance, I highly recommend incorporating my rear cooling system for E3DV6 Da Vinci 1.0 Pro into your setup as well. https://www.thingiverse.com/thing:2722109