D300VS SaberTusk

thingiverse

I was still struggling with achieving good bridges and overhangs at high printing speeds, so I opted for brute force cooling using two 5015 fans instead. The setup performs exceptionally well, but it can be too effective in some cases. To get the best results, make sure to add a sock to your hot end and recalibrate it as needed. Additionally, slow down your G-code ramp-up to prevent overheating. I typically limit my prints to 40% speed unless tackling complex overhangs or bridges. To secure the lower screw properly, I had to increase the grip length and use a spacer to achieve the correct thread engagement for the mount.