D20 Jail

thingiverse

It was asked for and now i am posting it. A completely remade model from the ground up. 5 gears, five faces.... Ah symmetry. follow the intructions on how to get it apart. i have given a standard dice holder as well as the capability to customize the holders. DO NOT PRINT WITH SUPPORTS FOR THE MAIN PIECE. When printing the screw in holders i recommend increasing the wall count or just 100% infill. I had one break of and it was annoying so be warned. The small basket and claw will fit your standard dice. How to separate the pieces https://youtu.be/dMQX08UnJSs Update Added a file for claws from 16-22mm (remember to print these with thicker walls or 100% infill and enough support to only support the flat bottom. 85 angle is my go to) Update 5/20/23 replaced model with new version. new version has shallower lower numbers so the overhang is easier to print Update 6/3/23 Tightened the ring to keep the sides from slipping and attached the ring to the main piece as the overhang would come off and cause a failed print. as a note this makes it a bit harder to get the pieces apart but they do eventually free up and work smoothly.