D-Line trunking fittings

thingiverse

I wanted some custom corners for a D-Line trunking installation I'm planning, so I decided to make my own. I've created all the ones I've designed to fit the specific configurations I needed; they are: * Corner-22Q+22Q.stl: A standard corner between 22 mm Quadrant trunking which serves as the basis for the next version. * Corner-22Q+22Q+15D.stl: As above, but with an outlet from the corner for 15 x 8 mm half-round trunking. I'll use this to take a small spur off the main trunking (22 mm quadrant running in a corner); since the spur is on an open wall, the half-round shape is preferred and 15 x 8 mm is big enough. * Corner-22Q+30D.stl: A corner for 22 mm Quadrant trunking on one side and 30 x 15 mm half-round trunking on the other; mirror the part if you want the opposite hand. This will be used to convert from 22 mm quadrant running in a corner to 30 x 15 mm half-round trunking running on top of the skirting board. * Joiner-30D.stl: A standard joiner for 30 x 15 mm half-round trunking, created because I was short of one and had already incorporated the shape in an earlier item. I have these as OpenSCAD files and may share them if there's enough interest. I could also be convinced to produce different designs if required.