D&D Dice Tray box with tablet stand

thingiverse

NOTE ON PRINTING THIS: Main files use pauses in print to place magnets! I added easier-to-print files with slots for dropping magnets into. I'm playing a group now that has limited table space, so I needed a dice tray for DnD Beyond. The lid stays in place thanks to magnets and when you take it off, it folds and slides into the slot as a tablet stand. The print used Tianse wood filament, which was then stained and sealed. Hinges are basic ones from a hardware store, and screws are spare motherboard stand-off screws that fit perfectly without going through the lid. There are twelve magnets embedded in total: six in the box, three each in the front handle, and rear flap. The magnets are rare earth, measuring 20x10x2mm. The box is exactly 220x220x40mm, fitting an Ender 3's build volume perfectly.