D-Bot Large Foot

thingiverse

I swapped the Z-Motor Mount brackets over to their topsy-turvy side, ripped out the front corner brackets, ordered a batch of large lead screws and hacked off the vertical rails of the D-Bot to boost overall printable height without breaking the bank. The bed now glides smoothly all the way down to the bottom rails with this redesign. These specialized feet give the Z-Motors plenty of clearance from the ground. Each foot makes use of four 5x12mm bolts and one large 5mm bolt - that same sturdy bolt used for the standard spool holder on the D-Bot. I went overboard with the design, but they're rock-solid and perfectly aligned with the Inner Corner brackets I came up with for the lower corner joints.