CZ457 455 452 512 Magazine Box for Extended Mags (12 round) With Sliding Lid

thingiverse

Note:12/13/2023 On request, added EZ fit lid versions that should require little or no edge dressing to fit. Tested one. Anyone using the EZ lid versions are welcome to leave comments so I may make further changes.12/11/2023 Added lid labeled for CZ455 and a Blank lid that can be easily remixed to add other text.This is a significant update of my original CZ457 magazine storage box, done in response to a request. It allows the use of 10 round magazines that have two round extensions added. The two round extension that I modeled after, https://www.thingiverse.com/thing:5400861 by ShortCourse, and its remixes will fit, though the box should fit almost any two-round extension. There is an attached STL you can use to verify fit of your particular magazine without needing to print the entire box. The container still fits unmodified 10 round magazines and the individual mag wells will even hold two five round magazines. The box is fairly robust, the one I printed at 30% zig zag infill is quite sturdy. Supports are not needed for the lid groove. The sliding lid is printed at 100%. I like fine tuning my sliding lids, so you will find it slightly wide and will need to dress the shoulders with a file. Takes about 5 minutes. I also recommend chasing the lid groove in the box with a Swiss file or bit of folded sandpaper, just to make sure it is clean and smoothI have also included an STL for the grass green mag well, seen in the photos, that I created the box around. This should facilitate remixes or custom magazine holders.Questions and requests are welcome.