CYMA VSS Hex barrel cover

thingiverse

I liked the hex barrel for the AS Val from COD MW so I basically copied it and made it print ready and work with my VSS. This is the second version (I never uploaded the first version because it was weak and didn't fit properly). This is for the CYMA VSS but it might work on other AS Val style airsoft guns. This is in white PLA spray painted matte black. To assemble it: Put the main part on the top of the barrel in the orientation seen in the picture. Proceed to slowly pull it down while slightly flexing it to fit around the front of the barrel and stop when it hits the handguard. Next, put the front connector on until it hits the main part, line up the the M4 screw holes, and screw the two parts together. Then, put the front part on the front connector, line up the M4 screw holes, and connect them via four M4 screws through the four holes in the front. Finally, put the top cover on as seen in the picture, line up the M4 holes, and screw them together with four M4 screws. A few things you'll need to get or do for this to work properly: 1. You will have to sand the insides down so The M4 holes will line up properly and so the parts will stay on without the screws (if you sand it just right the whole thing minus the top cover will stay on without the need of screws, I wouldn't recommend doing this though). 2. You will need 9 M4 x 30 mm screws. You can use smaller screws on the front to front connector and the front connector to the main barrel.